Checking with the community if others have been able to get IPv6 working on the XB7-T in bridge mode. I've recently switched from an SB8200 where I was able to get IPv6 working by setting my routers dhcpv6 to a /60. With current XB7 I can no longer get IPv6 to work, trying /60. Looking at modem config page shows a /64 prefix, which I understand means it cannot be further distributed. Anyone else figure out how to make this work?
On a related note, I'm not sure how much to make of this config page, because the IPv4 WAN address doesn't actually match my IPv4 obtained by the router.
↧