SB6120 - SB_KOMODO-1.0.6.14-SCM01-SH
pfSense - 2.1.5 and 2.2-BETA
I have been working fine pulling a /60 IPv6 prefix for several months.
On Sunday morning (10/19), I cycled my modem and it upgraded to the firmware noted above. That is the last time I was able to get a /60.
If I have the WAN set to request a /60, with hint enabled, I get a WAN address but no PD address at all. Again, that was a working configuration for several months, nothing changed except the modem FW upgrade.
If have the WAN set to request a /64, I get a WAN address and a /64 PD for a LAN interface.
NetDog??? Any thoughts or insight?
Of course I have powercycled the CM many times, rebooted pfSense many times and even totally re-imaged it.
↧